Flourescent Starter Units and Reflectors Controller starter units are required for all Flourescent tubes and are available in all sizes to suit individual tubes. In this section you will also find reflectors for Flourescent tubes which almost doulble the usable output of the light tube.

Show: 

4-80W Fluorescent Starter Switch

4-80W Fluorescent Starter Switch

With time, the starter switch of a magnetically ballasted controller invariably fails.
It is a simple task to remove the…

Arcadia Ultra Seal Replacement Leads 1in. (26mm) x 3m

Arcadia Ultra Seal Replacement Leads 1in. (26mm) x 3m

Theses are replacement lamp holder leads designed to be used with the Arcadia IP67 Ultra Seal Controller. Each pack contains…

Reptile Systems T8 Single Controller 14W - 15W and 20W

Reptile Systems T8 Single Controller 14W - 15W and 20W

High-quality electronic energy efficient ballast Easy to install Independent power switch. No flickering. Effectively reduces tension and stress on reptile pets. Long end-cap leads…

Reptile Systems T8 Single Controller 25W and 30W

Reptile Systems T8 Single Controller 25W and 30W

High-quality electronic energy efficient ballast Easy to install Independent power switch. No flickering. Effectively reduces tension and stress on reptile pets. Long end-cap leads…

Reptile Systems T8 Single Controller 36W - 38W and 40W

Reptile Systems T8 Single Controller 36W - 38W and 40W

High-quality electronic energy efficient ballast Easy to install Independent power switch. No flickering. Effectively reduces tension and stress on reptile pets. Long end-cap leads…

Result Pages: